The ideal total alkalinity level for swimming pools is 80-150mg/l (ppl). When the total alkalinity level is below 80mg/l (ppm) the pH level can fluctuate widely and the water can be corrosive, leading to damage to pool finish and support equipment. TA Plus is used to increase total alkalinity.
Application Instructions:
- Before applying this product, it should be pre-dissolved in a clean plastic container at a maximum rate of 100g of product to 10 litres of cold fresh water. Stir well to ensure that the product is fully dissolved. Repeat the application to achieve total dose required - see the label for dose rates.
- After pre-dissolving, add the resulting solution to the pool near the inlets with the filtration system in operation.
- Following the application, the pool water may become cloudy so keep the filtration pump running continuously until it clears.
- After treatment, check pH level and if necessary adjust to the ideal range of 7.2-7.6
Always read the label on the container fully before use.
This product has to be sent by courier
